used for HBot or Corexy.

Set arm_solution to corexy or hbot in config, for example, add this line to your configuration file : 

arm_solution      corexy

Then uncomment corexy_homing in config if using homing

Also it is recommended to set


to the top speed your steppers can go, as these refer to the actuator speed (the X and Y steppers) which on a corexy can run nearly twice as fast as the requested Cartesian speed when gong in certain directions.

This site is a WIki, which means you are very welcome to help us improve it. Help on how to do that can be found at the Editing the Wiki page . You can edit any page by clicking the "Edit" button bellow :