I have a Temp issue and not sure where to trouble shoot. This is on a MKS SBase V1.3 board (I know but I could not find a smoothie board in stock when I was looking to buy ), flashed with the January 2017 Edge firmware with a December 2016 Config File. Running Windows 10. I have formatted the SD Card last night as a precaution. I also have network enabled.
Recently I decided to connect my 2nd hot end. This is a brand new E3D V6. Hot end 1 is also a E3D V6.
Hot end #2 does not display the correct temperature in Repetier. Reads 100.00C if the thermistor cable is plugged in or not.
I have swapped the thermistor cables between HE1 and HE2 and the temperature does register as expected except the one plugged into hotend2.
I changed the pin configuration between the heated bed, hot end 1 and hot end 2. All registered except hotend 2.
Currently Heated Bed is Pin .23, Hot end 1 Pin .24 Hot end 2 Pin .25
I must be missing something in my Configuration file.. Can someone double check?