I just built my Delta printer with smoothie, very happy about that,
the printer do the zero sequence properly, all the manual jog are ok, I mean positive and negative jog, plus the z axis going up and down.
So i used the macro to set the nozzle to the bed center, G28:G0Z0F3500, All good
Then the macro for the Alpha Tower,G28:G0Z0X-80Y-40F3500, All good
Then the macro for the Beta Tower,G28:G0Z0X80Y-40F3500 here the problem: the Z axis is doing just 124mm of the 250mm to the Zero position and stop with the nozzle in the right place(X-Y), but half of the way to the bed Zero point (WHAT I'M DOING WRONG?)
Then the macro fot the Gamma Tower,G28:G0Z0X0Y80F3500, All good again, nozzle in position as the Alpha, except the Beta Tower……
If i look at the numbers going into the jog page i can clearly see that the Z is stopped at 124mm instead of 0mm as it should be as the other towers.
Any help is really apreciated, thank you