Doing a search I have seen that the Morgan printers running smoothieware have implemented a way to adjust the first layer height using a command entered into terminal during the print
Eg: M306.1 Z-0.05 brings the hotend closer to the bed during the print.
I tried using that M code on the latest firmware with no results. Is this a specific module that only works with Morgan printers?
Reason it's a useful feature: my printer will run multiple hotend configuration over the period of a few weeks depending on job requirements. Varying from e3d 0.25mm up to running a volcano 1.2mm. So I don't always have my z probe height perfect because it's always changing. It's good to be able to tweak the first layer height on the fly for different configurations.
Thank you for your time