G30 - noise issue, no return to starting point

Forum » Smoothie Firmware / General » G30 - noise issue, no return to starting point

Started by:

CLONEIT3D
Date: 10 Oct 2015 15:04
Number of posts: 3

RSS: New posts

Summary:

G30 - noise issue, no return to starting point

Unfold All Fold All More Options

Fold

G30 - noise issue, no return to starting point

CLONEIT3D 10 Oct 2015 15:04

I have the latest firmware loaded and I have been using the Smoothieboard for quite some time on my ordbot. I have an inductive z-probe. When I run a G30 command I get the proper read out of the distance traveled however when the probe triggers I get a loud noise like the steppers locked up and then it stops. The probe never returns to the starting point the way I think it is supposed to. I have adjust the debounce number high, low, and NC - to no avail. Anyone else have this issue or can you tell me why this happens?

Reply Options

Unfold G30 - noise issue, no return to starting point by

CLONEIT3D, 10 Oct 2015 15:04

Fold

Re: G30 - noise issue, no return to starting point

arthurwolf 10 Oct 2015 16:26

It's going back up too fast.

You need to lower the slow probing speed, or set the return feedrate to the slow homing feedrate's value or lower

Reply Options

Unfold Re: G30 - noise issue, no return to starting point by

arthurwolf, 10 Oct 2015 16:26

Fold

Re: G30 - noise issue, no return to starting point

CLONEIT3D 12 Oct 2015 01:16

Thank you!!!! Much appreciated - wish I had asked months ago.

Reply Options

Unfold Re: G30 - noise issue, no return to starting point by

CLONEIT3D, 12 Oct 2015 01:16

New Post

This site is a WIki, which means you are very welcome to help us improve it. Help on how to do that can be found at the Editing the Wiki page . You can edit any page by clicking the "Edit" button bellow :