I´ve done something wrong while setting up my 3d printer.
After great effort to get the wiring right. somehow i still got something wrong.
This is my setup:
GLCD from Robotseed
12V ATX PSU
and USB from my computer (to do the config).
Note that i´m running both 12V VCC and +5v from my PSU.
I haven´t soldered in the 5v voltage regulator.
This generated very little smoke, rushed to shut everything down, hope the damage is repareble! :/
How can i proceed? maby my combination somehow is bad or non-compatible?
Please point me in the right direction!
// Henrik; Sweden