New to the community!
I am wondering about using the smoothieboard for my next build as i like its scalable architecture.
As i am using it as a laser / 3d printer with the relevant safety precautions, i was wondering about the S0 comamd when specifying the laser intensity. the documentation says that G1 moves turns the laser on while G0 Turns It off.
ex. G1 X10 F100 S0
Question: for the following command above, even though my laser is on, if it has no intensity, is it still practically on?
Next question…As for the 3d Printer Side of Things,
If i specify say G1 X10 F100 E5 in my code:
a. Will that still turn on my Laser as its a G1 "turn on laser" Code or does it have to specify the S paremeter still?
B. My noobnes says to me if i don't specify either the E(command) or S(command), it should just move,
right or wrong?
Hoping not to go blind!!