So i may not be as smart as i think. That is probably true for most people. Not only did i fail at connecting this laser to my smoothie. Even though it is my third board. one mill and one 3d-printer before this. But i can't seem to find the search function on this forum either. Hence this thread.
Laser works just fine. Plug it in and push the button and it lasers.
Below is hopefully the board to the right are the pins.
From the the bottom right. two pins for laser power (already hooked up out of the box) . after that "PWM/TTL" (Not connected) and on the other connector "PWM/TTL" plus and minus.
I figure it is the last two i am supposed to use.I bet some one has done this before and can tell me?
I cant post a picture i am afraid.