Windows 10 drivers

I'm using a LPC1768 reference board with a Laoslaser board. I'm trying to use it with Smoothie but I'm not really sure how to assign the pins. I saw the pin list. Do I need to enter P24, 24 or P2.2?

G0 X500 will result in a movement of 50mm.

smoothieboards seem to be in short supply

Im building a 400x400 10lb bed 5 or 600 high corexy, z axis will be hanging off 3 leadscrews and 3 motors. It will be allot like the RailCore II 300ZL just stronger and bigger

I've upgraded, wired, etc. all to the wiki, but can't get a hint of movement.

The pinout diagram and the board are different.

One side of the bed is always lower than the other side

I activated this calibration but I dont want to do the probeing every single print

Button two should be disabled until button one has finished homing the machine. After that, button two enabled unconditionally.

Re-ARM for RAMPS and E3D PT100 and Amplifier.

This question pertains to how code is executed and deployed with the smoothieboard.

Azteeg x5 Compatibility