leveling-strategy.delta-grid.enable true The strategy must be enabled in the config, as well as the zprobe module.
leveling-strategy.delta-grid.radius 50 Radius of the bed, must be specified. This needs to be at least as big as the maximum printing radius as moves outside of this will not be compensated for correctly
leveling-strategy.delta-grid.size 7 The size of the grid, for example, 7 causes a 7x7 grid with 49 points. Must be an odd number.
leveling-strategy.delta-grid.probe_offsets 0,0,0 Optional probe offsets from the nozzle or tool head
leveling-strategy.delta-grid.save false If the saved grid is to be loaded on boot then this must be set to true
leveling-strategy.delta-grid.initial_height 10 Optionally an initial_height can be set that tell the intial probe where to stop the fast decent before it probes, this should be around 5-10mm above the bed

This site is a WIki, which means you are very welcome to help us improve it. Help on how to do that can be found at the Editing the Wiki page . You can edit any page by clicking the "Edit" button bellow :